Inseto
0 items - £0.00

SOS Wafers Further Information

Search

Showing all 8 results

Knowledge Base
Code

Diameter of the wafer listed in mm. Typically wafers are talked about in inches; typical sizes are 2”,3”,4”,5”,6”,8”& 12” – with 4”,6” and 8” the most commonly used in industry and academia.

This specifies the type of wafer, in the case of all SOS wafers this is SOS – Silicon on Sapphire.

SOS (Silicon on Sapphire). SOS wafers make use of a silicon layer grown on a sapphire substrate and are a specific subset of SOI wafers, where the insulator is sapphire.

This is an additional metric for describing the plane of the lower material (sapphire wafer). For R-plane this is (1102).

The resistivity of the upper material. This is often critical for SOS-based devices as they are used as the basis of the fabrication for CMOS devices and circuits.

The thickness of the wafer affects the mechanical properties and is typically expressed in µm (microns) and with a tolerance (± 20µm), The tolerance is measured through a total thickness variation (TTV).

This refers to the finish on the surface of the glass and can be either SSP or DSP.

Alignment fiducial refers to the flats or notches used to identify the wafer. Originally flats were used to identify TYPE and well as ORIENTATION, but now there is less convention about what the flats mean, and notches are quite common on 8” (200mm) wafers.

Coating thickness, typically µm, nm or Å.

If indicated with a positive "thumbs up" this product is in stock.

If the wafer you’re looking for is not listed we can usually still supply it.

Use this form to tell us the wafer specification and we’ll get back to you with a price and delivery time.

You can also call us +44 (0)1264 334505 or to email a general enquiry please use our Contact Page.

    Related Products